Project

General

Profile

Kaon LT Meetings » mtg_23apr27.txt

Garth Huber, 04/27/2023 07:58 PM

 
1
                 Apr 27/23 PionLT/KaonLT Analysis Meeting Notes
2
                 -----------------------------------------------
3
                           (Notes by GH and SJDK)
4

    
5
                    Today: KaonLT will be discussed first
6

    
7
Please remember to post your slides at:
8
https://redmine.jlab.org/projects/kltexp/wiki/Kaon_LT_Meetings
9

    
10
Present
11
-------
12
Regina - Stephen Kay, Garth Huber, Muhammad Junaid, Ali Usman, Alicia Postuma,
13
   Nathan Heinrich, Vijay Kumar, Love Preet
14
CUA - Tanja Horn, Richard Trotta
15
Ohio - Julie Roche, Jacob Murphy
16
FIU - Pete Markowitz
17
JLab - Dave Gaskell, Peter Bosted
18
CSULA - Konrad Aniol
19

    
20
Richard Updates
21
---------------
22
Tracking/lumi updates
23
   - Recap from 6/4/23 meeting, some runs were outside of the general trend
24
      - Bad TLT?
25
      - Will discuss with Jacob tomorrow about TLT calculation
26
      - if the TLT calc is fine, then will need to look more closely at the
27
        running conditions, and try to figure out what's wrong with these runs
28

    
29
Pion/proton subtraction, normalized to pi+n p+omega peaks
30
- Pion subtraction looking pretty good
31
- Proton subtraction dosn't look so good
32
   - somehow the proton distribution is missing the omega peak, but it 
33
     does show substantial pi+n leakthrough, and also a small K+Lambda peak
34
      - GH: it's essential that the pion and proton spectra used for background
35
        subtraction are clean, as otherwise you will subtract K+ too
36
      - No hole cut on HGC 
37
         - Just <= 1.5 on HGC for proton sample, which allows pi,K near hole
38
      - SK: Apply proton PID cuts, keep -5 to 5 in CT, then plot MM vs
39
        CT, see where 0.8 GeV peak is popping up
40

    
41
   - No Ref time cuts for pion/proton spectra
42
   - also need to re-check proton CT cuts
43
   - PeterB: What is the momentum here?
44
      - 10.6 GeV data, SHMS ~ 6 GeV/c
45
      - Pion/Proton are 0.5~ns separated in CT at 6 GeV/c
46

    
47
- Meeting with Ali on HGC next week
48
   - HGC is the top priority going forward
49

    
50
- To Do: Want to look at BPM calibrations too
51

    
52
Vijay Updates
53
-------------
54
Ratio of SIMC/Experimental yields
55
   - 8 t bins
56
   - 16 phi bins
57
   - plots at high, mid, low epsilon to show the code is working
58
- Experimental yields not finalized, so shouldn't expect much yet
59
- Ratios generally sensible for high, mid, low and low epsilon given the lack
60
  of iterations, but the phi distribution has a weird dip
61
   - thinks it's a SIMC model issue
62
   - DaveG: Could be an artifact of not having offsets, they aren't finalised
63
     yet
64
   - Peter B: is the 2.7-3 mrad Out of plane offset in?
65
         - Typical offset used for coincidence experiments
66
         - No, net yet
67

    
68
- Need to move back to yields, experimental data will move bin to bin
69
   - GH: Do not have SIMC model issues, you have experimental issues
70
      - Need to finalise offsets, rate dependencies etc then can come back to
71
        this
72
      - the data will migrate between different phi-bins, depending on the
73
        offset, so don't worry about the model or LT-sep until this is
74
        finalized and applied
75

    
76
Nathan Updates
77
--------------
78
Finished aerogel calibrations
79
   - Updated slides from last week, on redmine already
80
- Added new calibrations files and updated databases to git
81
- GH: Will have to check Redmine, do we have an area for calibrations?
82
   - If not, maybe a new area for this would be nice
83
   - otherwise, your final slides on the calibration will be difficult to locate
84

    
85
First look at the HMS cherenkov calibration
86
   - Got the existing code going
87
   - Ran for 15-20 runs or so
88
- GH: Selecting pi- to do the calibration?
89
   - Dave G - No, don't need pions to be high momentum, better to use delta
90
     knock-on electrons as source of low PE events
91

    
92
- PeterB: Use a run with a lower momentum setting for two reasons
93
   1) Higher pi- to e- ratio at low P
94
   2) Lack of pi- Cherenkov radiation
95
      - Threshold set to 4.5 GeV/c?
96
      - Dave G - Sounds about right
97

    
98
- Picked a random set of runs between 12000-16000, just ran them to check what
99
  they look like
100
   - Will do a more systematic pass now, looking more carefully at the pi-/e-
101
     ratio (see runplan spreadsheets) and the pi- Cherenkov threshold
102

    
103
Junaid Updates
104
--------------
105
HMS DC calibrations
106
   - 9.2 GeV beam energy, 2021 run
107
   - Applied electron cuts (HMS Cer NPE Sum > 1.5, HMS ETotNorm > 0.7)
108
     RED=before calib, BLUE=after calib
109
   - Residuals mostly improved, but still get double-peaked distributions for
110
     some planes
111
   - changed a few parameters and still waiting on second replay
112

    
113
   - DaveG: Does the code work by doing groups of 16 wires or individual wires?
114
      - Not sure, will need to check.  Not sure whether groups of 8 or 16 wires
115
        are used
116
   - Dave G: Time window cuts are applied?
117
      - Yes
118
   - GH: Who has the HMS calorimeter on their list?
119
      - Junaid
120
         - Working on calorimeter already too, modifying batch script
121
      - SK: Reminder to be a bit more selective with SHMS calorimeter
122
        calibrations, only want -ve polarity runs
123

    
124
Ali Updates
125
-----------
126
Heep Coin Analysis, offset studies
127
- Richard talked about the new SIMC kinematic variable calculations in the
128
  Quarterly Analysis Meeting
129
   - Using these when comparing with data
130
- Last week reported a constant 13 MeV shift in out of plane offset (Pmy)
131
  in all kinematics
132

    
133
- Juanid: What is the physical origin of the OOP offset?
134
   - AU: Correspondence to difference between two reaction/scattering planes
135
     compared to what we actually think
136
      - HeeP reaction is inherently coplanar
137
      - Physically, comes from spectrometer misalignment?
138
   - Dave G: Could be something in carriage that isn't flat, not pointing
139
     correctly
140
   - PeterB: Mark Jones believes it's a property of the magnets, magnetic axis
141
     of one spectrometer is a little bit offset
142
      - changes ThetaE (xptar) and adds 0.0027 to it
143
      - seems to be a property of the spectrometer, also had similar offset in
144
        6 GeV era
145
         - Add 2.7 mrad to -xptar (theta_e angle)
146
         - Lots of ways to check it, HeeP, asymmetries
147
      - TH: Yes, had two offsets in this era too
148
      - DG: Look at Fig 3.11 in TH thesis
149

    
150
- First look at Out of plane offset
151
   - Constant 13 MeV PMy shift
152
      - An angle offset works out into a momentum offset when you calculate
153
        momentum quantities, as a percentage of the spectrometer central
154
        momentum
155
   - Tried applying offset to SHMS first, smaller range of central momenta
156
   - found the angle offset needed to put PMy near zero
157
   - Plotted Pmy offset vs SHMS momentum
158
      - 6.2 beam: 0.0038
159
      - 8.2, 10.2 beam: both are 0.0030
160
      - projecting to higher P_SHMS would give significantly smaller offsets
161
        for physics settings 
162

    
163
   - Dave G/Tanja: How can you do this for Physics settings? Not kinematically
164
     constrained?
165
      - Could just use 0.003 everywhere
166
   - Tanja - Can't just use an offset/make one up to fix the data
167
      - These are just projections/expectations for physics offsets
168
   - GH: Should get error bars for three HeeP points, based on the widths of
169
     the PMy distributions, then I expect you will find a flat fit will be
170
     sufficient
171

    
172
   - Vijay: How can you get OOP offset without getting other offsets
173
      - Garth - OOP offset is independent of the others, since Heep reaction is
174
        coplanar
175
         - the HeepCheck program only gives the in-plane offsets
176
         - Can set/fix OOP offset, then use the HeepCheck program to get the
177
           rest, OOP offset is separate
178
         - Need to determine OOP first before determining the others
179
            - Didn't really fully appreciate this until last week
180
   - Vijay: Even after adjustment from Richard, plots still don't match
181
      - Ali: Yes but this is a limitation of the data
182
   - PeterB: What does Pmy correspond to?
183
      - xptar
184

    
185
   - PeterB: Actually looked at asymmetries of exclusive pions to determine
186
     this offset, didn't really have enough HeeP runs
187
      - Should take the events, calculate angle between two planes for HeeP
188
        settings you have
189
      - also looked at the azimuthal asymmetry of the exclusive pi+ events,
190
        although this is tricky because of the interference terms
191

    
192
   - PeterB: Previously found that it was more consistent to apply the offset to
193
     the HMS
194
      - Offset was consistent in 6 GeV era, only spectrometer in common is the
195
        HMS, implies it's an HMS issue
196
      - please try an HMS offset and see how well it works
197
      - DaveG: Figure 3.11 in Tanja’s thesis has a nice description of how to
198
        separate HMS and SHMS out of plane offsets
199

    
200
   - Peter is applying offset directly to xptar
201
      - GH: How do you do this?
202
         - recall that PB recalculates all variables from scratch via a script
203
         - xptar += 0.0027, manually reconstruct whatever is shifted
204
            - Recalculate all Physics variables from xptar etc
205
            - Only read in non-offset data from the replay
206
      - Plot coplanarity delta
207
      - Do it for all settings, see if coplanarity offset is independent of
208
        momentum
209
      - CYero found a slight dependence in the offset, but basically the same
210
        as PB
211

    
212
   - TH: it's important for everyone to be familiar with what was done in her
213
     thesis, Peter and Carlos work, etc.
214
      - try to learn from everyone's experience and not lose time working out
215
        the procedure
216

    
217
Very useful offsets discussion.  Summary to things for Ali:
218
- review TH, CY theses offsets discussions
219
- try an HMS OOP offset
220
- try estimating errors in each OOP offset as this affects what conclusions to
221
  draw when extrapolating to physics settings
222

    
223
Alicia Updates
224
--------------
225
- Finished exams on Tuesday
226
   - Hopefully something to show next meeting
227

    
228
- Experimenting with HGC cuts to see if it makes any difference in BSA data
229
- Getting SIMC running
230
   - MM changed significantly as a function of t
231
   - would like to see that pi+n peak looks like versus t
232
- Hopefully some of this to show for next week
233

    
234
Jacob Updates
235
-------------
236
- Welcome back Jacob :)
237
   - will meet with Junaid and Nathan next week
238

    
239
- PeterB asks about the status of optics
240
   - can show some delta-optimizations next week
241

    
242
Next Meeting
243
------------
244
- Thur May 4 @ 16:00 Eastern/14:00 Regina/13:00 Pacific
245
- PionLT will go first
(221-221/513)