Runlist » History » Revision 18
Revision 17 (David Flay, 01/15/2021 03:18 PM) → Revision 18/80 (Alexandre Camsonne, 01/15/2021 09:12 PM)
1. Runlist
beam hit the edge of top Ecal
New HV is: 1260, 1300, 920, 960, 940, 1940, 1780, 2100
Run
777 First run - MWPC trigger -
New HV is: 1260, 1300, 920, 960, 940, 1840, 1680, 2000
783 Preshower channels set to 2V range in FADC
784 TS1 and TS2 - move detector position so beam is hitting the center of three ECals
785
New HV is: 1160, 1200, 820, 860, 840, 1840, 1680, 2000
786 TS1 only - beam centered on calorimeter
New HV is: 1260, 1300, 820, 860, 840, 1740, 1580, 1900
787 lower HV on preshower
788
792
reduce 100 V more on preshower
793 short run PEB1 crashed
switch to FADC only config TiIntelvmeha8
795
Changing down stream Cerenkov N2 pressure
796 move to Top block
800 beam on the center of the top block, point A
801
802 beam on the center of the right block, point C
803 beam on the center of the left block, point A
804 beam on the center of 3 modules, 6.5k
805 2GeV, beam on the center of 3 modules, 31.7k
806 4GeV, beam on the center of 3 modules,
818 12 GeV e-
819 12 GeV e-
820 10 GeV e-
821 8 GeV e-
822 6 GeV e-
825
Switch to TS2 trigger