Runlist » History » Revision 21
Revision 20 (Alexandre Camsonne, 01/15/2021 09:25 PM) → Revision 21/80 (Alexandre Camsonne, 01/15/2021 09:31 PM)
1. Runlist beam hit the edge of top Ecal New HV is: 1260, 1300, 920, 960, 940, 1940, 1780, 2100 Run 777 First run - MWPC trigger - New HV is: 1260, 1300, 920, 960, 940, 1840, 1680, 2000 783 Preshower channels set to 2V range in FADC 784 TS1 and TS2 - move detector position so beam is hitting the center of three ECals 785 New HV is: 1160, 1200, 820, 860, 840, 1840, 1680, 2000 786 TS1 only - beam centered on calorimeter New HV is: 1260, 1300, 820, 860, 840, 1740, 1580, 1900 787 lower HV on preshower 788 792 reduce 100 V more on preshower 793 short run PEB1 crashed switch to FADC only config TiIntelvmeha8 795 Changing down stream Cerenkov N2 pressure 796 move to Top block 800 beam on the center of the top block, point A 801 802 beam on the center of the right block, point C 803 beam on the center of the left block, point A 804 beam on the center of 3 modules, 6.5k 805 2GeV, beam on the center of 3 modules, 31.7k 806 4GeV, beam on the center of 3 modules, 818 12 GeV e- 819 12 GeV e- 820 10 GeV e- 821 8 GeV e- 822 6 GeV e- 825 Switch to TS2 trigger 828 Switch back to TS1 831