SoLID DAQ » SoLID ECal

1. Runlist

beam hit the edge of top Ecal

New HV is: 1260, 1300, 920, 960, 940, 1940, 1780, 2100

Run     

777  First run - MWPC trigger - 

New HV is: 1260, 1300, 920, 960, 940, 1840, 1680, 2000

783 Preshower channels set to 2V range in FADC

784 TS1 and TS2 - move detector position so beam is hitting the center of three ECals

785

New HV is: 1160, 1200, 820, 860, 840, 1840, 1680, 2000 

786 TS1 only - beam centered on calorimeter

New HV is: 1260, 1300, 820, 860, 840, 1740, 1580, 1900

787 lower HV on preshower

788

792

reduce 100 V more on preshower

793 short run PEB1 crashed

switch to FADC only config TiIntelvmeha8

795 

Changing down stream Cerenkov N2 pressure

796 move to Top block 

800 beam on the center of the top block, point A

801

802 beam on the center of the right block, point C

803 beam on the center of the left block, point A

804 beam on the center of 3 modules, 6.5k

805 2GeV, beam on the center of 3 modules, 31.7k

806 4GeV, beam on the center of 3 modules,

818 12 GeV e- 

819 12 GeV e- 

820 10 GeV e- 

821 8 GeV e-

822 6 GeV e- 

===========1GeV===================

HV is: 1260, 1280, 760, 860, 880, 1640, 1480, 1800

823

824

825

Switch to TS2 trigger

828 

Switch back to TS1

831